Yeah, it's been fun for me running models (mostly Qwen 3.6 27B) on my 48GB M4 MacBook Pro. When i'm using it to run models, it's basically unusable for anything else - I actually do the work on my Macbook Neo. Took me a while to figure out why the models couldn't figure out how to make tool calls - because LMStudio by default uses a 32K input window, which is smaller than OpenCode's prompt, so half of the instructions were being pruned from the middle!
Yes — there is a setting for that isn't there. And as soon as you realise there's a setting for that, you have new knowledge.
Qwen barely needs any of Opencode's prompt, in my experience; I think I cut it down to about three general lines I found by googling. Mainly you need only a pre-amble to make sure that the plan mode, plan switch and build mode prompt fragments make sense.
Gemma 4 also needs almost nothing at all, which is fascinating, considering it is not a coding-specialist model. It just seems to be who you need it to be when you ask.
What are those 3 lines you've cut it down to?
[dead]